Stop the GenAI Studio setup job
POST/api/genai-setup/stop
Ends the running setup step and the steps queued after it; the step is reported as failed with the message that it was stopped. During the start step this stops GenAI Studio with run.sh stop, and the start step waits to be run again. Does nothing when no job runs.
Request
Responses
- 200
- 409
- 502
- 504
Each setup step's state after stopping.
The board or a command on it could not be used. code identifies the failure and hint names the recovery step.
The board or a command on it could not be used. code identifies the failure and hint names the recovery step.
The board or a command on it could not be used. code identifies the failure and hint names the recovery step.